Flood-Freeze-Overheat Wireless Sensor

The Resolution Products RE319 wireless Flood sensor will trigger an alarm when liquid rises 0.040 inches above sensor bottom. It will also trigger a "Freeze" alarm notification when room temperature drops below 40F or an "Overheat" alarm notification when room temperature rises above 100F.

This sensor is compatible with DSC wireless controls.

Features

•Tri-Mode Environmental Sensing:
    Flood/Moisture Sensor
    Freeze – for Furnace Failure
    Overheat – for Furnace runaway or Air Conditioning failure.

•3 unique wireless IDs or Loops: one for each function

•Cover tamper.

•Strong, reliable RF signal.

•8-10 year battery life on CR123A battery.

•Low Battery indication.

•3.3x1.4x1.1 inches

Specifications

This sensor is compatible with DSC wireless controls.

Flood sensing:     Titanium contacts 100K-Ohm nominal (DO NOT use an EOL resistor) Transmitter handles 1 or 2 flood elements, no more.
0.04 inch floor spacing to eliminate floor condensation falses. Checks for moisture every 5 seconds: needs two positive moisture checks to send Flood alarm.  (test mode: every second when cover is off)

Freeze Alarm:     45F +/- 2F  (custom temps available) Restores when temp increases 4F from alarm

Overheat Alarm Temp:  100F +/- 2F  (custom temps available) Restores when temp decreases 4F from alarm

Mounting hardware:   #6 or #8 screws
                                 Dual Mode mounting:
                                 
Screwed to floor
                                 
Screwed to wall

Terminal wire capacity:  16 Gauge

Replacement Battery:  CR123A 1550 mAH

Temperature Range:   0F to 120F

Housing dimensions:   3.3x1.4x1.1 inches