0 items Tech Support

2GIG-PIR1-345 - 2GIG Wireless Pet Immune Motion Sensor

2GIG-PIR1-345 - 2GIG Wireless Pet Immune Motion Sensor
Manufacturer:  2GIG Technologies  SKU:  2GIG-PIR1-345
Rating: [4]   Write a Review | Read Reviews
In Stock
Usually leaves our warehouse the same business day.

This motion detector is a great way to secure your home, but still allow pets to move freely anywhere in the house. It’s a cinch to install too.

Price:  $51.59

Image Viewer  Show Picture 1

This passive infrared motion detector is meant for use with the 2GIG Alarm System and is a wall-mounted unit with wide angle motion protection. When set to High Sensitivity Mode, the PIR has a maximum range of 30 ft. deep X 50 ft. wide. The PIR is pet immune up to 55 lbs.

  • Dual element sensor with 30 ft. by 50 ft. range
  • 33 or 55 lb. pet immune
  • 90-degree look down
  • Lithium battery with 5 years life
  • 110deg. spread
  • 3 different mounting brackets
  • Tamper protected
  • Fully supervised
Rating: (2.25)   # of Ratings: 4   

Sort: New to Old RE-SORT REVIEWS:

Showing comments 1-4 of 4
1. J. Castellana on 1/9/2014, said:

It appears that people are saying that this sensor does not work. This is not true at all. What people don't realize is that it does work the first time you stand in front of it. After that, it goes to sleep for 3 minutes to save battery life. If it did not have this sleep feature then it may detect 1000 or more times draining the battery. Remember, it needs to go off only once to get an intruder. You may want to actually arm the system and come in like an intruder to really test it. You may have to do this a few times. I would do this before you are using monitoring. Keep in mind that there are a little better sensors out there, but you might pay twice as much. However, this sensor does do what it is supposed to do, especially in small to medium rooms.

Was this comment helpful? yes no   (0 people found this comment helpful, 0 did not)
2. Anonymous User on 2/17/2012, said:

I purchased this to add on to my 2-gig system. Does not sence movement very well. I tried many options and failed. I contacted the company behind the 2-gig system. They are sending me a new and improved sensor. Its nice to know you have them to back you up

Was this comment helpful? yes no   (3 people found this comment helpful, 0 did not)
3. Anonymous User on 10/7/2011, said:

very bad sensor does not detect motion reliably even when set to high sensitivity

Was this comment helpful? yes no   (3 people found this comment helpful, 0 did not)
4. Anonymous User on 6/1/2011, said:

I have installed many wireless security systems and motion detectors and this by far is the worst Motion detector that I have ever installed. Here is a list of problems that I encountered: Cause low battery trouble after it has been installed for a few hours even after installing new batteries. Stops communicating with the Panel. Simply does not pick up motion / persons even after the 3 minute sleep period. you can put it into test mode and set the panel to chime and you will see that it simply does not pick up motion 3/4 of the time even the test light does not illuminate most of the time. poor construction. Even the mounting system is horrible. Myself and my installers spend more time installing and troubleshooting this motion than installing the whole system. will never use again.

Was this comment helpful? yes no   (7 people found this comment helpful, 1 did not)
Showing comments 1-4 of 4
PIR Motion Detector (2GIG-PIR1-345)
Wireless Signal Range 350 ft.., open air, with 2GIG Wireless Alarm Control Panel
Code Outputs Alarm; Alarm Restore; Tamper; Tamper Restore; Supervisory; Low Battery
Transmitter Frequency 345.000 MHz (crystal controlled)
Transmitter Frequency Tolerance ± 15 kHz
Transmitter Bandwidth 24kHz
Modulation Type Amplitude Shift Keying—On/Off Keying (ASK-OOK)
Unique ID Codes Over one (1) million different code combinations
Supervisory Interval 70 minutes
Peak Field Strength Typical 50,000 uV/m at 3m
Sensor Type Quad element
Pet Immunity Selectable: 15 kg (33 Ibs.) or 25 kg (55 Ibs.; default)
Sensitivity Jumper Selectable: High or Low (default) ^
Suggested Mounting Height 7.5 ft. (2.3 m)
Sensor Range 30ft. (9.1m) x 50 ft. (15.2m)
Maximum Horizontal Sensing Angle 90= ., .- *
Dimensions (LxWxH) 3.2 x 2.5 x 1.9 in. (8.12 x 6.35 x 4.82 cm)
Weight (including battery 81 bracket) 3.7 oz. (104.9 g)
Housing Material ABS plastic and poly-carbonate
Color White
Operating Temperature 32° to 120°F (0° to 49°C)
Relative Humidity 5-95% Non-Condensing
Batten/ (included, not installed) One (1) Panasonic CR123A, or equivalent Lithium battery
Regulatory Listings ETL, FCC Part 15, Industry Canada „_,
Warranty* Two (2) years *"
`Included Accessories Mounting brackets, two (2) long Phillip's head screws, two (2) plastic wall anchors, magnet
Installation Guide
Downloads: 212
Size: 579 KB