ELK110 - ELK Voice and Siren Driver Module |

|
The ELK-110 Voice Driver features high quality digitally recorded voice messages and loud attention getting siren sounds in an economical, low current draw, compact package. It features two input channels, multilingual voices, and many unique options which allow it to be used with virtually any residential or commercial alarm installation. The MilliMiser option allows the already low current draw to be further reduced for controls with limited alarm output power. Combo Trigger allows controls which have a single alarm output and pulsing option to activate both the burg and fire alarm sounds. The Volume Step option is best described as the "peacekeeper", since it causes the siren sound to start at low volume, gradually increasing over 90 seconds to maximum volume. |
|
|
The ELK-110 Voice "Talking" Driver features high quality digitally pre-recorded voice messages and loud attention getting siren sounds in an economical, low current draw, compact package. It features two input channels, bilingual voices (English and Spanish), and many unique options which allow it to be used with virtually any residential or commercial alarm installation. The voice messages and the siren alternately sound whenever one of the channels are activated.
Installer Friendly - Compact & Easy to Mount
Two Input Channels, Burglar & Fire
Bilingual Voice - English and or Spanish, Siren Only, Speech Only, or Combined
MilliMiser-; Lowers Current Draw
ComboTrigger-For Single Outputs
VolumeStep-Slowly Increases Siren Volume
Temporal Coded Fire Signal
Pre-Wired For Easy Installation
Lifetime Limited Warranty |
Operating Voltage:
Current Draw:
Sound Level:
Max. Speaker Load:
Size: |
10 to 14 Volts DC
1.25 Amps, (800 mA on MilliMiser™setting), with one 8 Ohm speaker
120 db @ 1 meter, 14 vdc, with one 8 Ohm speaker
4 Ohms
2.75" x 4.0" (70mm x 102mm) |
|
|

|
|